This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
|
||||||
|
||||||
The model SND is a low proximity hood capable of providing up to 90% total make-up air through an optional rear discharge make-up plenum (SND-BR). Hood shall have size, shape and performance specified on drawings. Construction shall be type 430 stainless steel with a #3 or #4 polish where exposed. Individual component construction shall be determined by manufacturer and ETL. Construction shall be dependent on the structural application to minimize distortion and other defects. All seams, joints, and penetrations of the hood enclosure to its lower outermost perimeter that directs and captures grease-laden vapor and exhaust gases shall have a liquid-tight continuous external weld in accordance with NFPA 96. Hood shall be wall type with a minimum of four connections for hanger rods. Connectors shall have 9/16" holes pre-punched in 1 ½" x 1 ½" angle iron at the factory to allow for hanger rod connection by others. The hood shall be furnished with U.L. classified filters, supplied in size and quantity as required by ventilator. The hood manufacturer shall supply complete computer generated submittal drawings including hood sections view(s) and hood plan view(s). These drawings must be available to the engineer, architect and owner for their use in construction, operation and maintenance. Exhaust duct collar to be 4" high with 1" flange. Duct sizes, CFM and static pressure requirements shall be as shown on drawings. U.L. incandescent light fixtures and globes shall be installed and pre-wired to a junction box. The light fixtures shall be installed with a maximum of 40" spacing on center and allow up to a 100 watt standard light bulb. The hood shall have:
The hood shall be ETL Listed as "Exhaust Hood Without Exhaust Damper", ETL Sanitation Listed and built in accordance with NFPA 96. The hood shall be listed for 400°F cooking surfaces at 228 CFM/ft and 600°F cooking surfaces at 294 CFM/ft. The hood shall be ETL Listed as "Exhaust Hood Without Exhaust Damper". A built-in wiring chase shall be provided for outlets and electrical controls on the hood face and shall not penetrate the capture area or require an external chaseway. |
||||||
|
||||||
|
||||||
|