The model AM-SND is a low proximity hood capable of providing up to 90% total make-up air through an optional rear discharge make-up plenum (AM-SND-BR). Hood shall have size, shape and performance specified on drawings.

Construction shall be type 430 stainless steel with a #3 or #4 polish where exposed. Individual component construction shall be determined by manufacturer and ETL. Construction shall be dependent on the structural application to minimize distortion and other defects. All seams, joints, and penetrations of the hood enclosure to its lower outermost perimeter that directs and captures grease-laden vapor and exhaust gases shall have a liquid-tight continuous external weld in accordance with NFPA 96. Hood shall be wall type with a minimum of four connections for hanger rods. Connectors shall have 9/16" holes pre-punched in 1 ½" x 1 ½" angle iron at the factory to allow for hanger rod connection by others.

The hood shall be furnished with U.L. classified filters, supplied in size and quantity as required by ventilator.

The hood manufacturer shall supply complete computer generated submittal drawings including hood sections view(s) and hood plan view(s). These drawings must be available to the engineer, architect and owner for their use in construction, operation and maintenance.

Exhaust duct collar to be 4" high with 1" flange. Duct sizes, CFM and static pressure requirements shall be as shown on drawings.

U.L. incandescent light fixtures and globes shall be installed and pre-wired to a junction box. The light fixtures shall be installed with a maximum of 4’0" spacing on center and allow up to a 100 watt standard light bulb.

• A double wall insulated front to eliminate condensation and increase rigidity.
• An integral baffle to direct grease laden vapors toward the exhaust filter bank.
• The grease drain system shall be an enclosed integral part of the hood back and have slope with an exposed, removable ½ pint grease cup to facilitate cleaning.

The hood shall be ETL Listed as "Exhaust Hood Without Exhaust Damper", ETL Sanitation Listed and built in accordance with NFPA 96. The hood shall be listed for 400°F cooking surfaces at 228 CFM/ft and 600°F cooking surfaces at 294 CFM/ft. The hood shall be ETL Listed as "Exhaust Hood Without Exhaust Damper". A built-in wiring chase shall be provided for outlets and electrical controls on the hood face and shall not penetrate the capture area or require an external chaseway.

• Utility Cabinet
• End Panels
• Back Supply Plenum
• Enclosure Panels
• Captrate Combo®, Captrate Solo®, high efficiency stainless steel baffle, stainless steel baffle, and high velocity cartridge filters